StencilLaser G 6080

The StencilLaser G 6080 represents everything LPKF is renowned for: Worldwide leadership in designing highly sophisticated products, inspired by customers. The second generation StencilLaser G 6080 is designed to rapidly produce assured quality at minimum cost.

Having out-performed every commercially available laser system used in stencil production for the last years LPKF continues to expand its innovation. Focusing R&D efforts on the highly dynamic motion systems allowed us to improve the StencilLaser G 6080's cutting throughput by 20 % compared to its predecessor.

This combination of heightened performance and cutting quality with increased system uptime adds greater flexibility, higher throughput and faster delivery.

Designed for 24/7 Use

The LPKF StencilLaser G 6080 is designed for permanent and professional use with minimal maintenance requirements. The proven LPKF LongLife fiber laser technology is now 100 % air-cooled. This reduces the system's total power consumption by about 30 % while eliminating service and maintenance downtime for any external chiller system.

The StencilLaser G 6080 can use either compressed air or oxygen for cutting. In fact, it can even be operated with two different cutting gases on the same job. The selection of the gas type, as well as pressure adjustment and monitoring is all fully automatic. The setup is cutting tool dependent, allowing the operator to use the most appropriate gas type for the job at hand. As part of the parameter set, cutting gas is controlled for every single aperture type. This feature helps saving cost on more expensive cutting gases, such as oxygen, while also delivering the highest possible cutting quality where it really counts.